Summit SUM-900932 Manual

SUM-900934
Properties
This small, efficient, and extremely light weight
welder is suitable for a range of different projects.
The use of a long extension cord eases operation in
various sites. It is also suitable for generator use on
construction sites.
Welding voltage and wire feeding speed are adjusted
with knobs control according to the thickness of the
welded sheet. Thus, selecting the right parameters is
easy.
The machine's welding properties are optimum with
a steel wire of 0.8 mm diameter. Also, 0.9 mm solid
wire or flux cored wire can be used as filler wire.
About Welding
For best results the recommendations in the manual
should be followed.
During welding, electric current is led with the weld-
ing gun's current nozzle to the filler wire via the wire
to the welded piece. The ground clamp (earth cable)
attached to the work piece guides the current back
to the welder, this forms the needed closed circuit.
Unrestricted current flow is possible only when the
ground is properly attached to the work piece. The
work piece must be clean, paintless and rust-free.
WWW.SUMMITRACING.COM
MIG Welder
SUM-900932 SUM-900933
Introduction to your new Mig welder
This is an easy-to-use MIG welder suitable for both hobby and
professional use. Before using or doing any maintenance work on
your welder , please read the operating manual and keep it for
further reference.
SUM-900933
Shielding gas must be used under gas mode during
welding in order to prevent air from mixing with the
weld pool. Carbon dioxide or a mixture of carbon
dioxide and argon is suitable for shielding gas. Some
filler wires form a shielding gas from the wire's filling
as it melts thus eliminating the need for a separate
shielding gas.
SAFETY INSTRUCTIONS
Be aware that there are some risk factors connected
to welding, therefore be sure to read the guide and
follow the safety instructions carefully.
The welding gun has an overheating protector which
prevents operation when the machine is getting too
hot. The welder also has built in protection for too
high or too low voltage.
Protective Accessories
Always wear an approved welding helmet, protec-
tive gloves and sleeves. The reflecting radiation can
damage unprotected eyes while the welding arc and
sparks can burn your unprotected skin. Summit
Racing also offers a wide variety of welding protec-
tive gear and consumables.
SUMMIT BRAND TECH : 330.294.9747
SUM-900934
SUM-900932