Summit SUM-900938 Manual

Introduction to your new Plasma Cutter
We are dedicated to providing you with the best
possible equipment and service to meet the demanding
projects that you have. We want to go beyond
delivering a satisfactory product to you. That is the
reason we offer technical support to assist you with
your needs should an occasion occur. With proper use
and care your plasma cutter should deliver years of
trouble-free service.
SAFETY
Safe operation and proper maintenance is your
responsibility. We have compiled this operator's
manual, to instruct you in basic safety, operation and
maintenance of your product to give you the best
possible experience.
Please carefully read this manual before you operate
your unit. This manual is not only for the use of the
machine, but to assist in obtaining the best perfor-
mance out of your unit. Do not operate the unit until
you have read this manual and you are thoroughly
familiar with the safe operation of the unit.
The warranty does not cover improper use,
maintenance or consumables. Do not attempt to alter
or change any piece or part of your unit, particularly
any safety device. Keep all shields and covers in place
during unit operation should an unlikely failure of
internal components result in the possible presence of
sparks and explosions. If a failure occurs, discontinue
further use until malfunctioning parts or accessories
have been repaired or replaced by qualified personnel.
WWW.SUMMITRACING.COM
Plasma Cutter
SUM-900938
WARNINGS
High Frequency electromagnetic disturbances:
Certain welding and cutting processes generate High
Frequency (HF) waves. These waves may disturb
sensitive electronic equipment such as televisions,
radios, computers, cell phones, and related
equipment. High Frequency may also interfere with
fluorescent lights. Consult with an electrician if
disturbance is noted. Sometimes, improper wire
routing or poor shielding may be the cause.
High Frequency can interfere with pacemakers.
See EMF warnings in following safety section for
further information. Always consult your physician
before entering an area known to have welding or
cutting equipment if you have a pacemaker.
WARNING! Persons with pacemakers should
not weld, cut or be in the welding area until they
consult with their physician. Some pacemakers are
sensitive to EMF radiation and could severely
malfunction while welding or while being in the
vicinity of someone welding. Serious injury or death
may occur!
WARNING! Do not weld on or cut galvanized steel,
stainless steel, beryllium, titanium, copper,
cadmium, lead or zinc without proper respiratory
equipment and or ventilation.
SUMMIT BRAND TECH : 330.294.9747