56
5. The Sequencer
RECORDING AN ORIGINAL PATTERN — REAL TIME
1.
Select a Pattern Number
In the PATTERN mode, select the number of the pattern you want to edit
or record.
Clear the Current Pattern.
If you want to record a totally new pattern from scratch, clear the existing
pattern: press the SUB MODE [JOB] key, use the PAGE [
locate the "PTN JOB Clear Pattern" screen.
PTN`JOB`Clear`Pattern`````ptn```````````
[PTN]`ALL``KEY`<Funk```V>`I00w``````````
Press [F1] so that the square brackets appear around "PTN" on the display.
This means that you want to clear a single pattern. If necessary, use [CS6]. to
select the pattern you want to clear, then press [ENTER/YES].
PTN`JOB`Clear`Pattern`````Are`you`sure`?
[PTN]`ALL``KEY`<Funk```V>`I00w``````````
Respond to this "Are you sure ?" display by pressing [ENTER/YES] again
if you want to go ahead and clear the pattern, or press [EXIT/NO] to cancel
the operation.
2.
Set the Pattern Record Parameters
Engage the Record Mode.
Press the sequencer [RECORD] key to engage the record standby mode.
The red [RECORD] indicator will light.
PATTERN`RECORD`Meas`Tempo`Time`Qntz`Vel`
`REAL``PTN=I00````1``120``4/`4``1/4`norm
Select a Record Mode.
Use [CS1] to select the desired record mode. The different record modes
are:
REAL (Real-time Overdub)
Material recorded in the overdub mode is recorded "over" any previous
material, so you end up with a combination of the previous and newly-
recorded data.
k
l
] and [
] keys to