Load The Pre-Programmed Voice, Performance, & Pattern Data - Yamaha SY-85 Owner's Manual

20
1. Setting Up Your System
Load the Pre-programmed Voice, Performance, & Pattern
Data
Although the factory pre-programmed voices, performance combinations,
and patterns are stored in the SY85 internal memory when the instrument is
initially shipped, there is always a possibility that all or part of the memory has
been erased or modified by the time the instrument gets to you. Here's how
you can re-load all the pre-programmed data.
Loading the pre-programmed data overwrites any other data
that is in the SY85 internal memory, so if you have any
important data in memory make sure it is safely stored to disk
IMPORTANT
before loading the demo data.
1.
Insert the DATA Disk
Insert the DATA disk into the disk drive. The sliding disk shutter should go
in first, and the label side of the disk should face upward.
2.
Select the Utility DISK ALL LOAD Function
Press the [UTILITY] button so that its indicator lights, then press the SUB
MODE [DISK] key (the lowest SUB MODE key). A display with the word
"DISK" in the upper left corner should appear.
DISK`All```````<--NEW--*>```````````````
[LOAD]SAVE```````Disk=01``¥`Internal````
If necessary, press the PAGE [
display shown above appears. Also press the [F1] key to make sure that the
LOAD function is selected (the square brackets should appear around "LOAD"
on the display).
3.
Load the Data
Press the [ENTER/YES] once. "Are you sure?" will appear on the display.
Press [ENTER/YES] a second time to actually begin loading the data.
DISK`All```````<--NEW--*>```````````````
```````**`BUSY`**`Now`executing`!```````
"** BUSY ** Now executing !" will appear on the display while the data
is being loaded.
4.
Eject the Disk
When the data has finished loading press the eject button, below the disk
drive slot, to eject the DATA disk, then store the disk in a safe place.
k
] key a few times until the "DISK ALL"