Dual Pitch (Preset Bank) - Yamaha SPX2000 Owner's Manual

Effect list
The following tables show the default parameter values for the effect belonging to the High Quality Pitch type (PRESET
bank).
■Basic parameters
No.
Effect name
58
ROGER ON THE 12
■Fine parameters
No. Effect name
58 ROGER ON THE 12

Dual Pitch (PRESET bank)

This is essentially the same as High Quality Pitch, but there are two effect sounds whose pitch can be specified independently.
Each aspect of the sound is controlled by the following effect parameters.
Effect sound 1: PITCH 1, FINE 1, DELAY 1, FB.G 1, MODE
Effect sound 2: PITCH 2, FINE 2, DELAY 2, FB.G 2, MODE
Tempo synchronization:
LEVEL 1, LEVEL 2, MIX BAL.
Output level:
Parameter details
■Basic parameters
Parameter name
PITCH 1
PITCH 2
FINE 1
FINE 2
DELAY 1
0.0—1000.0 ms
DELAY 2
FB.G 1
–99%—+99%
FB.G 2
LEVEL 1
–100%—+100%
LEVEL 2
PAN 1
PAN 2
■Fine parameters
Parameter name
MIX BAL.
MODE
SYNC
NOTE 1
NOTE 2
TEMPO
*a.
62
SPX2000—Owner's Manual
PITCH FINE
+12 0
MIX BAL. OUT LVL
100% 90%
SYNC, NOTE 1, NOTE 2, TEMPO
Range
Amount of pitch change, adjusted in semitone steps. Positive (+) settings make the pitch higher
–24—+24
than the original sound, and negative (–) settings make it lower.
Amount of pitch change, adjusted in steps of one cent (1/100th of a semitone). Positive (+) settings
–50—+50
make the pitch higher than the original sound, and negative (–) settings make it lower.
Delay of the effect sound relative to the original sound.
Amount of feedback for the effect sound. Raising this value will increase the amount of feedback,
emphasizing the pitch change. Negative (–) settings will invert the phase of the feedback.
Output levels of the effect 1 and effect 2 sounds. LEVEL 1 is the output level for effect sound 1, and
LEVEL 2 is the output level for effect sound 2.
Negative (–) settings invert the phase.
L63—R63 Position of each effect sound. L63 is far left, and R63 is far right.
Range
Balance between the original sound and effect sound. At a setting of 0% only the original sound
0—100%
will be output; at a setting of 100% only the effect sound will be output.
Precision of the pitch change. Higher settings produce a more accurate pitch change, but the delay
1—10
error will be greater.
Switches tempo synchronization on/off. If this is ON, the delay time will synchronize to the tempo
synchronization source specified by the "TEMPO SOURCE" setting (page 23). The NOTE 1 and
ON, OFF
the NOTE 2 value will be set to the synchronized tempo value.
These parameters are used for tempo synchronization. If SYNC is ON, the DELAY 1 value will be
*a
set according to the NOTE 1 and TEMPO values, and the DELAY 2 value will be set according to
the NOTE 2 and TEMPO values. If SYNC is OFF, this value is ignored.
These parameters are used for tempo synchronization. If SYNC is ON, the DELAY 1 value will be
set according to the NOTE 1 and TEMPO values, and the DELAY 2 value will be set according to
25—300
the NOTE 2 and TEMPO values. If SYNC is OFF, this value is ignored.
DELAY FB.GAIN
0.0 ms 0%
MODE SYNC NOTE
6 OFF
TEMPO
—
Explanation
Explanation