Table of Contents
Advertisement
Before plugging in, ensure that the voltage
and frequency shown on the rating plate
correspond to your domestic power supply.
The appliance must be earthed. The power
supply cable plug is provided with a contact
for this purpose. If the domestic power
supply socket is not earthed, connect the
appliance to a separate earth in compliance
with current regulations, consulting a
qualified electrician.
The manufacturer declines all responsibility
if the above safety precautions are not
observed.
NOTE: Do not place heavy objects on top
of the refrigerator.
To minimize the risk of rusting, leakage,
and insulation damage, avoid placing the
unit where heavy moisture is present.
Under no circumstances apply or let
water spill onto or into the unit.
Leveling Your Refrigerator
Your refrigerator has 2 leveling legs.
After properly placing your unit in its final
position, adjust the legs by turning them
clockwise to raise the refrigerator or
counterclockwise to lower it. If the unit
is not level, the doors and magnetic seal
will not be aligned properly.
Using Your Refrigerator
Important:
• Before connecting the refrigerator to a
power source, let it stand upright for
approximately 24 hours. This will reduce
the risk of any malfunction to the cooling
system that might have occurred during
handling and/or transporting, and will
allow the refrigerant to flow back into
the compressor.
• When using the refrigerator for the first
time, allow at least 24 hours for the
internal temperature to adjust properly.
Your refrigerator should be on a flat
surface that is strong enough to support
it when fully loaded.
Operating instructions
Before using the refrigerator for this first
time, clean the interior with a damp cloth.
Wipe down the shelves and interior walls,
and dry with soft cloth.
Temperature Control
The internal temperature is controlled by a
thermostat. There are 8 settings. 1 is warmest
setting, 7 is coldest setting, and 0 is off.
Helpful Hints for Food Storage
• When storing fresh food that is not
prepackaged, be sure to wrap or store
food in airtight and moistureproof material
unless otherwise noted. This will ensure
proper shelf life and prevent the transfer
of odors and tastes.
• Wipe containers before storing to avoid
needless spills.
• Hot food should be allowed to cool before
storing in the refrigerator. This will prevent
unnecessary energy use.
• When storing meats in the refrigerator,
keep in the original packaging or rewrap
as necessary.
How to Change the Interior Light
Warning: Before replacing the light bulb,
disconnect the refrigerator from main
power supply.
Follow below process to replace the
lightbulb:
1. Set the temperature regulation knob at
number "0" to switch off.
2. Remove the screw of the lamp cover.
7
Advertisement
Table of Contents
