Advertisement
I RS60A Assembly
* A screw driver (+ or -) is necessary to complete the assembly.
Please make sure that the fixing bolts on each part, such as clamps, pads, etc. are firmly tightened.
Bolts that are too tight or too loose may result in damage to the part or the part dropping. Please use caution.
1
Insert the Center Bar
sembly
and Right Side Assembly
clamps on the Center Pipe
Assemblies and tighten all fixing bolts.
Tighten
Tighten
Attach the Center Bar
Left Side Assembly
2
Attach the Module Holder
2-1
Insert the Hex Rod Cylinder
, and tighten the fixing bolts.
2-2
Attach the Module Holder Clamp
Left Side Assembly
2-3
Attach the DTXPRESS to the Module Holder
driver and the supplied screws, attach the Module Holder
the screw hole on the bottom of the DTXPRESS.
2-4
Attach the Module Holder
to the Module Holder Clamp
Step 2-3
Hex Rod Cylinder
Tighten
Attach the Module Holder Clamp
Left Side Assembly
into the tube clamps on the Left Side As-
. Then slide the tube
onto the Left
and Right
Attach the Center Pipe
Tighten
Tighten
Right Side Assembly
into the Module Holder Clamp
to the upright pipe on the
.
. Using a screw
, with the DTXPRESS attached,
.
DTXPRESS
Module Holder
Step 2-4
Step 2-1
Step 2-2
Attach the Drum Pad Clamps
3
Side
3-1
Insert the Hex Rod Cylinders
and tighten the fixing bolts.
3-2
Attach the Drum Pad Clamps
locations.
3-3
Insert the Hex Rod Cylinder
and secure.
4
Attach the Cymbal Holders
4-1
Insert the Cymbal Holders
that are attach to the left and right sides of the Center Pipe
and tighten all fixing bolts.
4-2
Attach the Cymbal Pad to the Cymbal Holders
position and tighten the fixing bolts. (Refer to the Cymbal Pad's
Owner's Manual for instructions on attaching the cymbal pad to
the cymbal holder.)
Hex Rod Cylinder
Cymbal Holder
Drum Pad Clamp
to
Drum Pad
After the above assembly is complete, set the Kick Pad, Hi-Hat Con-
trol Pedal, etc. into position and connect the necessary cables. To
keep cable out of the way while playing, use the supplied Cable Bands
to hold the cables to the rack systems's pipes.
into the Drum Pad Clamp
to the tom tom and hi-hat
into the Pads, adjust the angle
into the Cymbal Holder Clamps
Step 4-2
Cymbal Pad
Drum Pad Clamp
Tighten
Step 3-2
Step 3-3
,
,
, adjust the
Cymbal Holder
Step 3-1
Step 4-1
Printed in Taiwan
Advertisement
