Advertisement
I RS60 Assembly
* A screw driver (+ or -) is necessary to complete the assembly.
• Over-tightening of the fixing bolts may result in damage. Take care when tightening fixing bolts and screws.
• When attaching the pads and the DTXPRESS to the rack, make sure their weight is not extremely unbalanced. Also, take into consideration
the forces that are applied while playing the RS60 so that it can be played in a stable condition without excessive deflection.
1
Attach the Center Pipe Assembly
and the Right Side Assembly
Tighten
Left Side Assembly
2
Attach the Module Holder
2-1
Insert the Hex Rod Cylinder
, and tighten the fixing bolts.
2-2
Attach the Module Holder Clamp
pipe.
2-3
Attach the DTXPRESS to the Module Holder
driver, use the screws included with the Module Holder to at-
tach the holder to the bottom of the DTXPRESS.
2-4
Attach the Module Holder
to the Module Holder Clamp
Step 2-3
Hex Rod Cylinder
Tighten
Attach the Module Holder Clamp
Left Side Assembly
to the Left Side Assembly
, and tighten the fixing bolts.
Attach the Center Pipe
Tighten
Right Side Assembly
into the Module Holder Clamp
to the Left Side Assembly
. With a screw-
(with the DTXPRESS attached)
.
DTXP
Module Holder
Step 2-4
Step 2-1
Step 2-2
3
Attach the Drum Pad Clamps
3-1
Insert the Hex Rod Cylinder
and tighten the fixing bolt.
3-2
Attach the Drum Pad Clamps
cations.
3-3
Insert the Hex Rod Cylinder
and secure.
Attach the Cymbal Holders
4
4-1
Insert the Cymbal Holders
that are attach to the left and right sides of the Center Pipe
and tighten all fixing bolts.
4-2
Attach the Cymbal Pad to the Cymbal Holders
position and tighten the fixing bolts. (Refer to the Cymbal Pad's
Owner's Manual for instructions on attaching the cymbal pad to
the cymbal holder.)
Hex Rod Cylinder
Cymbal Holder
Drum Pad Clamp
Step 3-3
After the above assembly is complete, set the Kick Pad, Hi-Hat Con-
trol Pedal, etc. into position and connect the necessary cables. To
keep cable out of the way while playing, use the supplied Cable Bands
to hold the cables to the rack systems's pipes.
into the Drum Pad Clamp
to the tom tom and hi-hat lo-
into the Pads, adjust the angle
into the Cymbal Holder Clamps
, adjust the
Step 4-2
Cymbal Pad
Drum Pad Clamp
Cymbal Holder
Tighten
Step 3-1
Step 4-1
Step 3-2
,
,
Advertisement
