Advertisement
■ Optional Parts
● Pad and Drum Trigger Grouping
q DTXTREME
II
w PCY130/130S
S
Drum Trigger Module
Cymbal Pad
t TP100
y TP120SD
Drum Pad
Drum Pad
u KP65
i Foot Pedal
Kick Pad
* DFP-9310 etc.
● Monitor System and Attachement Grouping
• SPAT1
• CYAT150
(1 set L/R units)
• MS50DR
• Satellite
• Sub Woofer
Speakers
amp unit
3
Attaching the DTXTREME
3-1
Remove the module holder from the holder clamp, and
use the supplied screws to attach the DTXTREME
Make sure only the supplied screws are used. Using any
other screws may result in the unit falling off the holder
or damage.
3-2
Slide the module holder, with the DTXTREME
attached, into the holder clamp.
Step
3
II
DTXTREME
S
Module
Holder
Step 3-2
Step 3-1
Holder Clamp
Maker sure all bolts on clamps, pads, etc., are tightened firmly.
However, loose or over-tightened bolts may result in the part falling off and/or damage. Please use caution.
After assembly is complete, setup the kick pad, real hi-hat pad, etc., and connect the cables. Use the supplied cable bands to secure the cables
to the frame pipes to keep cables out of the way during performance.
If the rack is moved even after setup is complete, make sure the bolts are loosened before moving the rack.
e PCY150S
r RHH130
Real Hi-hat Pad
Cymbal Pad
o Snare Stand
!0 Hi-hat Stand
*SS652 etc.
*HS-740 etc.
• TPCL150
• MS100DR
• Sub Woofer
• Satellite
amp unit
Speakers
II
S
II
S.
II
S already
Step
5
■ Set up example
PCY130S
Satellite Speaker
w
q
y
r
o
!0
4
Attaching the cymbal pads
Attach the cymbal pads to the cymbal holders and adjust their
position, then secure in place. (Please refer to the Owner's
Manual that came with the cymbal pads on attaching the cym-
bal pads.)
5
Attaching the drum pads
Attach the drum pads to the tom clamp and adjust their posi-
tion, then secure in place.
Drum Pad
Satellite Speaker
PCY150S
e
t
u
i
Sub Woofer amp unit
Step
4
Felt
Cymbal Pad
(PCY130/130S/150S)
Anti-swivel brace
(supplied with the
(PCY130/130S/150S)
w
PCY130
t
Printed in Indonesia
WG24090
Advertisement
