Table of Contents
Advertisement
Precautions
1. Warranty Card
The serial number is written on the rear panel of this unit. Copy the
serial number and model number onto your warranty card and keep
it in a safe place.
2. Recording Copyright
Recording of copyrighted material for other than personal use is il-
legal without permission of the copyright holder.
3. AC Fuse
The fuse is located inside the chassis and ts not user-serviceable. If
power does not come on, contact your Onkyo authorized service
Station.
4. Care
From time to time you should wipe the front and rear panels and the
cabinet with a soft cloth. For heavier dirt, dampen a soft cloth in a
weak solution of mild detergent and water, wring it out dry, and
wipe off the dirt. Following this, dry immediately with a clean cloth.
Do not use rough material, thinners, alcohol or other chemical sol-
vents or cloths since these could damage the finish or remove the
panel lettering.
5. Power
WARNING
BEFORE PLUGGING
IN THE UNIT FOR THE FIRST TIME,
READ THE FOLLOWING SECTION CAREFULLY.
@ Some models are designed for use only with the power supply
voltage of the region where they are sold.
European and Australian models:
AC 230V, 50Hz
U.S.A. and Canadian models:
AC 120V, 60Hz
Worldwide model:
AC 220-230V/120V switchable,
$0/60Hz
® Voltage Selector (Rear Panel)
Worldwide models are equipped with a voltage selector to con-
form to local power supplies. Be sure to set this switch to match
the voltage of the power supply in your area before plugging in
the unit. Models without a voltage selector can only be used in
areas where the power supply is the same as that of the unit.
Turning off the power switch does not shut off the power completely.
So the power cord should be removed from AC outlet when not in
use for a prolonged time.
Supplied accessories
te
1) a
1 Remote control (RC-295S)
1 Remote control cable
2 Batteries (size AA, R6, or UM-3)
1 AM loop antenna
1 T-shaped FM antenna
The following accessories are only available
for worldwide models.
Ws
LS 2
(
1 75/300 ohm antenna
adaptor
1 CV piug (Shape may vary
according to the area where
purchased.)
Setting the voltage selector and tuning step
frequency (Worldwide models only)
gases
or nar
Sn
coeee
cna
ee
decent,
SSEEEEREEEEE
SSSI
Su
aaa
SL
SS
AM FREQ. STEP
veut Low
Be
SS RERSR VERS SS TH SSIS SSSR SSR SEAR SRT TR TESST SR SST SNE SIRS
ESSER
SUS
UM Se
cian cne ie Ya
aa Rate
Caco
oa ac
VOLTAGE SELECTOR
220-230V ™
120V™~
a
| 1. Determine the proper voltage for your
|
area: 220-230V or 120V.
: 2. Ifthe preset voltage is not correct for your
:
area, insert a screwdriver into the groove
:
in the switch. Slide the switch all the way
| __ to the right (120V) or to the left (220-
/
230V), whichever is appropriate.
Worldwide models are equipped with a
switch that controls the AM band tuning
steps. Please set this switch to match the AM
band tuning step frequency in your area.
RO
CNR
saa
aes
Sea
ea a Saas
eee
ESC
U.S.A. and Canada : 10kHz
.
Other areas
: 9kH2
Advertisement
Table of Contents
