Table of Contents
Advertisement
t
VOLUME
Sets the output level of the signal from
Insertion Effect and the bypassed signal
sent to the Reverb Effect Unit.
y
COARSE
Sets the pitch in coarse increments
(semitones).
u
FINE
Fine-tunes the pitch.
i
RESO
Sets the LFO Resonance level.
o
CUTOFF
Sets the LFO Cutoff Frequency.
!0
ATTACK
Sets the Attack Rate.
!1
DECAY1
Set the Decay1 Rate.
!2
DECAY2
Set the Decay2 Rate.
!3
LEVEL
Sets the output level of the wave.
!4
PAN
Sets the Pan position of the wave.
!5
INSERTION ON/OFF
Selects whether or not to send the signal to
the Insertion Effect Unit.
Parameter Knob Operation
You can change the operation of the parameter knobs. Right
click on any knob, and select "Rotate" or "Up/down or left/
right."
When "Rotate" is selected, the parameter values (of the panel
"knobs") are changed by clicking and dragging the mouse in a
circular direction.
When "Up/down or left/right" is selected, the parameter values
(of the panel "knobs") are changed by clicking and dragging
the mouse vertically or horizontally.
The setting made here affects all knobs.
NOTE
!6
REVERB
Sets the Reverb Send Level.
This parameter has no effect if the
Insertion effect (!5 ) is on.
!7
RECEIVE NOTE ON
Selects whether or not to receive the MIDI
Note On message.
!8
RECEIVE NOTE OFF
Selects whether or not to receive the MIDI
Note Off message.
!9
KEY ASSIGN
Selects Single key assignment or Multi key
assignment.
@0
ALTERNATE GROUP
Selects an alternate group number. This is
used to prevent a pair of drum sounds,
such as an open and closed hi-hat, from
sounding simultaneously.
@1
PITCH
This graph shows the y and u settings
visually. You can also change the settings
by dragging the squares in the graph.
@2
FILTER
This graph shows the i and o settings
visually. You can also change the settings
by dragging the square in the graph.
@3
AMPLITUDE EG
This graph shows the !0 , !1 and !2
settings visually. You can also change the
settings by dragging the squares in the
graph.
17
Advertisement
Table of Contents
