Samsung QN49Q6FAMF Service Manual page 23

3. Disassembly and Reassemble
Description & Screws
3
Use Open Jig to release tape in corners and
all clips as indicated in red on sides and top &
bottom.
Gently lift up the Rear Cover starting at the top
being careful of function assembly at the bottom.
When the Upper 4 points (
•
broken.
Although the hook is broken, the appearance
of the Rear cover is no problem and Gap
problem is not appeard after re-assembly.
• To prevent the Inner Hook's broken.
1. Catch the upper section of the rear cover.
2. Open the rear cover from top to bottom.
•
If the wire is bent, need to change the wire.
• Panel Back Side View
49 / 55 inches
-
4
Remove the Electric tapes, Remove them.
NOTE
• When assembling the TV, the electric tapes
must be applied on the same locations.
Please remember to take a picture of
where the tapes were first applied.
• When assembling the Boards, please make
sure All Board Mounting Clips are securly
inserted.
3-2
)Hook is
Caution
Picture Description
Jig Direction
Top
: 10 point Locking
Center
: 1 Point Locking
Bottom
: 4 point Locking
Dressing Sliding Fixing Point Filament Tape