Yamaha MW10 Owner's Manual page 12

Quick Guide
2
Use the [Stereo Switch] buttons in the
Inspector to select stereo or monaural
operation for the track: (
operation and (
For the example select the stereo mode.
You will normally use a monaural track when recording
vocals or guitar, and a stereo track when recording
synthesizers with stereo outputs, for example. You
might want to use a stereo track to record a guitar
processed through a preamplifier or amp simulator
with stereo outputs.
3
Select [Mixer] from the [Devices] menu to
open the mixer window.
Click the arrow in the upper left corner of the mixer
window and select [Wide] to increase the width of the
mixer's channel strips. Leave the mixer window open
until you have finished recording for easy access.
[Record Enable]
button
Channel strip
4
Make sure that the [Record Enable] button
( ) on the left side of the channel strip is
on.
If the [Record Enable] button is off (
it on. The input signal level will be displayed on the
channel strip level meter while the [Record Enable]
button is on.
5
Play the instrument to be recorded and,
while watching the mixer window level
meter, adjust the MW10 GAIN controls,
Channel LEVEL Controls, and ST Master
LEVEL Control so that the meter never
goes above 0.0 dB.
n The Cubase LE channel strip fader only affects the
playback output level from Cubase LE.
12
MW10 Owner's Manual
) for stereo
) for monaural.
), click it to turn
The maximum level encountered is displayed
numerically in the peak level display at the top of the
channel strip.
Peak level display
6
Specify the point at which you want to
start recording via the ruler at the top of
the project window.
Click the black area of the ruler to move the project
cursor (the vertical black line) to that position.
7
Open the [Transport] menu and turn [Start
Record at Left Locator] off.
Recording and Playback
1
Click the Transport panel [Record] button
to begin recording.
When recording is started the project cursor will begin
moving to the right and a box that displays the
recording results will be created.
Transport panel
Rewind
Forward
2
Play the part.
3
When you have finished recording the
track, click the Transport panel [Stop]
button.
Record
Play
Stop
Recording results