Table of Contents
Advertisement
Inserting
a scene from
a VCR - Insert
Editing
(1) Set the POWER
switch
to VTR.
(2) On the VCR, locate just before the insert start point [a], then press I I to set the VCR
to the playback
pause
mode.
(3)On your camcorder,
locate the insert end point [c] by pressing
_
or I_1_. Then
press
|1 to set it to the playback
pause
mode.
(4) Press ZERO SET MEMORY
on the Remote Commander.
The ZERO SET MEMORY
indicator
flashes and the end point of the insert is stored in memory.
(5)On
your camcorder,
locate the insert start point [b] by pressing
,91_, then press
• REC and the button
on its right simultaneously
to set your camcorder
to the
recording
pause
mode.
(6) First press I I on the VCR, and after a few seconds
press I I on your camcorder
to
start inserting
the new scene.
Inserting
automatically
stops near the zero point on the counter.
Your camcorder
automatically
stops. The end point
[c] of the insert stored
in memory
is canceled.
5
m
ZERO SET
MEMORY
To change
the
insert
end
point
Press ZERO SET MEMORY again after step 5 to erase the ZERO SET MEMORY
indicator
and begin from step 3.
Notes
• The zero set memory
function
works only for tapes recorded
in the Digital8
l) system.
• The picture
and sound
recorded
on the section
between
the insert start and end points
will be erased
when
you insert the new scene.
When the inserted picture is played back
The picture
may be distorted
at the end of the inserted
section. This is not a
malfunction.
To insert a scene without
setting the insert end point
Skip step 3 and 4. Press • when
you want to stop inserting.
63
Advertisement
Table of Contents
