CEBEK R-13 Manual

Cebek manual regulator day and night effect. The duration of the selected effect can be adjusted between 1 second
and 60 minutes according to the chosen time scale.
Includes indicator led & protection fuse Adaptable to Din-Rail ref. C-7567.
POWER SUPPLY 230 VAC. Use a network cable and plug (both must withstand a minimum of 10A). Connect it to
the "INPUT AC" terminal. Install a switch for protection and safety as per CE standard
OUTPUT CONNECTION. Connect the load to be controlled to the "Output A.C." terminal. Remember that it only
supports light bulbs incandescent, does not support PL lamp, LED or fluorescent bulbs. The load should consume a
minimum of 50 W. and a maximum of 1500 W.
DAY / NIGHT EFFECT. Connect a switch to the "SWICH" terminal. Try to be of quality.
With the switch open, a progressive start-up starts from off to maximum.
With the switch closed, a progressive shutdown starts from maximum to shutdown.
The duration time of the ramp or effect can be selected by choosing between the 2 available scales and
adjusting the circuit potentiometer.
After the effect is complete, the output will remain fully on or off, depending on the function selected, until you
change the switch position or restart the power.
RAMP ADJUSTMENT. The duration of the fade-in or fade-out effect will depend on the selected time.
With the "Ecale" switch and the RV 1 potentiometer and it will be the same for the on and off ramp.
With the "Ecale" switch select between scale 1 to 60 seconds or 1 to 60 minutes.
Using the potentiometer, "RV1" that incorporates the circuit, you can adjust the ramp between a minimum and
maximum time of the chosen scale.
INSTALLATION. Do not install the circuit outdoors, install it in a plastic box for protection and safety.
The box must have ventilation slots, the circuit during its operation dissipates heat, poor ventilation will reduce its
performance and may damage it. The output is with triac, it can generate interference on other devices. If this
happens, install a 230 V input line filter.
Day / night manual regulator
Régulateur manuel jour / nuit
Regulador manual día / noche
Regulador manual dia / nit
www.cebek.com - sat@fadisel.com
R-13
Technical characteristics
Voltage : 230 V. AC.
Consumption : 1 w.
Minimum Load : 50 W.
Maximum Load : 1500 W.
Timing scale A : 1 to 60 seg.
Timing scale B : 1 to 60 min.
Fuse : 8 Amp
Sizes : 98 x 72 x 42 mm.
Weight :89 grs.
Din rail : C-7567