CEBEK I-16 Quick Start Manual

E L E C T R O N I C C I R C U I T S
2000 W. LIGHT REGULATOR. 2000 W. LIGHT REGULATOR.
With the I-16 circuit yoou could adjust the luminous intensity of any lamp till 2000 W. (maximum) and
other reistives load (i.e resistors) are accepted.
Circuit is supplied with 220 VAC and does not accept inductives load (halogen lights, transformers,
etc...).
It includ connection terminals.
TECHNICAL CHARACTERISTICS.
Operating Voltage. .................................................................. 220 V. A.C.
Minimum Operative Load. ....................................................... 50 W.
Maximum Consumption. ........................................................ 2.000 W.
Power Variation. ....................................................................... From 3% until 98%.
Hysterisis Level. ........................................................................ Inferior than 3%.
TECHNICAL DESCRIPTION.
MODULE'S POWER SUPPLY.
insulate the module from parasites using a filter for mains (220 VAC).
See the paragraph "How to install the Filter". Following general wiring map, you had to use correct plug and
cable to connect it to the 220 VAC input terminal. Install a fuse and a switch (both are necessary for the
module and your own safety as you could note in the CE regulations). The verify that the assembly is correct.
Before to connect the switch to supply tht module you had to do all indicated connections. Do not forget that
in the circuit yo have 220 VAC.
OUTPUT CONNECTION-LOAD.
inductive loads as halogen lamps, transofrmers, etc...
To connect the output, see the "General Wiring Map" to connect it to the load to the indicated terminal.
OPERATING.
When input and output connections are made and checked, you could activated switch to
supply the module and thanks to the indicated potentiometer, you could adjust the output intensity. If you
adjust the potentiometer to the left, the intensity will decrease. If you adjust it to the right, the intensity will
increase.
INSTALLATION.
Do not install the I-16 module at bad weather even if it is protected against meteorological
conditions. You had to fit the circuit in to a metallic enclosure.
The I-16 circuit is supplied with 220 VAC. To obtain a correct operating, you had to
For this reason you gad to be very careful.
The module only accept resisitve loads as resistors, etc.... It never could control
1 1
I-16 I-16