Yamaha GO46 Owner's Manual page 22

GO46 Control Panel
ROUTING
Selects the output signal sent from the OUTPUT 1/2, OUTPUT 3/4, and DIGITAL OUT jacks. All
input signals (DAW IN 1/2, DAW IN 3/4, DAW IN 5/6, ANALOG IN, DIGITAL IN, and DIGITAL
MIXER) can be routed to the three output pairs
open a pull-down menu from which you can select the desired pair. If you intend to use the
digital mixer, [DIGITAL MIXER] must also be selected on the input side, otherwise the signal will
be sent straight to the output, bypassing the faders.
OUTPUT
The levels of the OUTPUT 1/2 and OUTPUT 3/4 can be controlled here. The individual faders
control the levels of the analog signal output from the D/A converter. A separate fader is available
for each mono channel. The individual channels can be joined using the switchable stereo link
function. As in the Digital Mixer window, the [MUTE] buttons can be used to mute the individual
channels and the [PAIR] buttons can be used for the stereo link function.
The fader operation in the OUTPUT section can also be completely linked with the Master knob
on the front panel.
The ASIO control panel (Windows only)
Selects a latency value (delay in playing the audio signals) when using the ASIO driver. To open
the ASIO panel, click the [ASIO] button on the bottom left side of the Output & Settings window.
If the value is too low (and the sample rate too high), this will negatively affect the performance
of your overall system, introducing noise and dropouts.
A more powerful computer will support a lower latency setting. With a fast system, you should
achieve values of less than 5ms at 96kHz. If problems occur, increase the latency as needed.
Further options are generally available on the relevant panels of ASIO applications such as
Cubase, etc.
22
*
. Click the three buttons on the left-hand side to
* For the DIGITAL OUT jack, you can select
"NON AUDIO" (as shown above). In this
case, AC3 and DTS data will be transmitted
only via the digital output.