Replacing The Airclean Exhaust Filter; Replacing The Airclean Plus 50, Silence Airclean 50, Active Airclean 50 And Hepa Airclean 50 Exhaust Filters - Miele Complete C3 Score Red PowerLine Operating Instructions Manual

en
Replacing the AirClean exhaust
filter (Fig. 38 + 39)
Do not use more than one exhaust
filter at a time.
 Open the dust compartment lid (Fig.
09).
 Press the release catch on the filter
grille and open the grille until it clicks
(Fig. 38).
 Grasp the used AirClean exhaust filter
by one of the clean, unsoiled sections
and take it out (Fig. 38).
 Replace it with a new AirClean ex-
haust filter (Fig. 39).
If you wish to fit an AirClean Plus 50,
Silence AirClean 50, Active
AirClean 50 or HEPA AirClean 50 ex-
haust filter, see the "Replacing one
type of exhaust filter with another"
section.
 Close the filter grille (Fig. 39).

Damage due to contamination in
the dust compartment
Large quantities of dust may enter
the dust compartment and damage
components if the dustbag has not
clicked into position.
Before closing the dust compartment
lid, make sure that the dustbag has
been inserted so that it has clicked
into position.
 Close the dust compartment lid se-
curely, making sure it clicks into posi-
tion. Take care not to trap the dustbag
when doing so.
66
Replacing the AirClean Plus 50,
Silence AirClean 50, Active AirClean
50 and HEPA AirClean 50 exhaust fil-
ters (Fig. 40 + 41)
Do not use more than one exhaust
filter at a time.
 Open the dust compartment lid (Fig.
09).
 Lift the exhaust filter and remove it
(Fig. 40).
 Insert a new exhaust filter, making
sure it goes in properly, then press it
down into position (Fig. 41).
 If you are using exhaust filter c, d or e,
you must also activate the timestrip®
filter change indicator (Fig. 11).
After approx. 10–15 seconds, a thin red
line will appear in the left-hand side of
the display (Fig. 12).
If you wish to fit an AirClean exhaust
filter, see "Replacing one type of ex-
haust filter with another".

Damage due to contamination in
the dust compartment
Large quantities of dust may enter
the dust compartment and damage
components if the dustbag has not
clicked into position.
Before closing the dust compartment
lid, make sure that the dustbag has
been inserted so that it has clicked
into position.
 Close the dust compartment lid se-
curely, making sure it clicks into posi-
tion. Take care not to trap the dustbag
when doing so.