Setupand Configuration - PR TANGO 680 SPOT DE User Manual

Table of Contents

Advertisement

4. SETUPAND CONFIGURATION

●FRONT PANELOPERATION
A projector's configuration can be set conveniently via push button and LCD display.
Launch the projector and press button ENTER for more than 5 seconds to unlock the panel, the LCD will show the function menu of the
projector, each main menu has its submenus and each submenu has a specific function. For details, please see the "OPERATION
MENU" section.
To set up or browse through its functions, press button UP or DOWN
Press button ENTER to save your settings or enter the submenu.
Press button UP or DOWN to change values(plus or minus)
Press button FUNC, it will return to the upper menu. If button FUNC not pressed, the default will show display status automatically.
DMX STARTADDRESS
Each unit must be given a DMX start address so that the correct projector responds to the correct control signals. This DMX start address is
the channel number from which the projector starts to "listen" to the digital control information being sent out from the controller. The unit
has 3 DMX modes. There are standard mode ,short mode and extended mode. For example standard mode has 17 channels, so set the No.
1 projector's address 001, No. 2 projector's address 018, No. 3 projector's address 035, No. 4 projector's address052, and so on.
Launch the projector. Press button ENTER more than 5seconds to unlock panel.
Press button ENTER to display DMX address;
Press button UP and DOWN, you can set the address;
Press button ENTER to confirm; after powered on next time, the default will be last value saved. The keys in the control panel need to be
adjusted against unintended touch
Press button FUNC, it will return to the upper menu
.
DMX WIRELESS CONTROL
The projector has wireless control function with wireless receiver module and antenna for remote control.
The setup of it is below:
1.
Enter into the projector's menu. Select the menu "Config Settigns" via the bottoms of
Select DMX control Mode---- Wireless First (Note: do not select XLR ONLY),then wireless indication in the front
2.
panel will be on, meaning wireless control function is activated.
Only after the projector is linked with a transmitter, can it receive wireless signal sent by the transmitter. If unlinking it, Press
"Enter" for the menu of Unlink Wireless under the upper level menu of Config Settigns .
STAND-ALONE MODE
Operate the projector without connecting with a controller, enable the master mode through the operation panel, the
projector will run in Stand-Alone mode automatically.
DMX address can be set at any number within 512.
●MASTER/SLAVE MODE
Many projectors can run synchronously in the Master/Slave mode by linking them with each other. First,
connect the first fixture's DMX output to the second fixture's DMX input using XLR-XLR control cable and then connect the second
fixture's DMX output to the third fixture's DMX input, and so on until all projector are connected in this way. Eventually connect the last
fixture's DMX output to a DMX terminator. Set 1
(If the projector has the function)
st
projector as the master and others are Slaves. It's advised that the
8
UP and DOWN

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pr-6629

Table of Contents