Safety Information; Set-Up And Usage - LEITZ ERGO 65370085 Instructions For Use Manual

Instruction Manual
Thank you for choosing Leitz Ergo
The Space Saving Dual Monitor Arm is intended to securely hold two monitors, elevate them off the
desk surface, and reduce eye strain and discomfort. It's adjustable, and frees up desk space. This
product is not intended for outdoor use.

Safety information

WARNING
• Read and understand this manual, including the technical specifications.
• This product is not a toy. Make sure children and pets do not play with the product.
• Before installing, make sure that the mounting location does not contain any electrical
wiring or mechanisms that could be damaged during installation.
• Only use this monitor arm with monitors or displays that are within the weight and size
limits specified in these instructions.
• Keep hands, fingers, and any other body parts away from any moving parts or areas where
two parts come together. Failure to do so may result in serious personal injury.
• This product contains small items that could be a choking hazard if swallowed. Keep these
items away from children.
• Do not over-tighten screws or bolts, this can cause damage to the product or the mounting
surface.
• Make sure that the mounting surface will safely support the combined weight of the
product and all attached hardware and components.
• Only use the mounting hardware provided.
• Do not use excessive force when adjusting the position of the monitor, as this can damage
the arm or the monitor.
• Check that the clamp and attachments are secure at regular intervals (depending on the
amount of usage). Retighten the clamp or attachments if necessary.
• This product is intended to be used in an indoor office or home environment.
• Keep all safety information and instructions for future reference. The manufacturer is not
liable for material damage or personal injury caused by incorrect handling or use.
Product overview ①
A. Monitor arm
B. Centre brace
C. Limit screw
D. Monitor brackets
E. Clamp plate
F. Clamp
G. Clamp holder
H. Clamp bracket

Set-up and usage

1. Unpack and check the contents.
Put the rubber pads Ⓟ on the bottom of the centre brace Ⓑ.
2.
3. Measure the thickness of the desk.
If the desk is between 10mm and 40mm thick, follow steps ��.
•
If the desk is between 40mm and 85mm thick, follow steps ��.
•
• If the desk has a grommet between 10mm and 60mm in diameter and the desk is
between 10mm and 80mm thick, follow steps ��.
14
ID_DUAL.indd 14 ID_DUAL.indd 14
I. Guide clips
J. Cable guide
K. Grommet bolt
L. Grommet bracket
M. Nut
N. Bracket screws
O. Clamp screws
P. Rubber pads
Q. Thumbscrew
R. Split washer
S. VESA screws
T. VESA washers
U. Wrench
V. 4mm Allen key
W. 6mm Allen key
5-5-2023 16:46:01 5-5-2023 16:46:01