This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: This device may not cause harmful interference ● This device must accept any interference received, including interference that may cause ● undesired operation www.flammainnovation.com Shenzhen Flamma Innovation Co., Ltd...
4. Can optionally be powered by 48v phantom power 5. Line in function supports signal from microphone amplifier or FV series pedals 6. Two different output modes for mixed signal or individual signal from guitar and microphone www.flammainnovation.com Shenzhen Flamma Innovation Co., Ltd...
Lay out REVERB LINE IN GAIN XLR OUT LIFT MODE DC IN TONE 9V 1.5A www.flammainnovation.com Shenzhen Flamma Innovation Co., Ltd...
Page 6
MIC: Microphone signal input jack GAIN: Microphone signal input gain level LINE IN: Line signal switch 48V: Phantom power switch XLR OUT: Balanced XLR output jack LIFT/GND: Balanced output grounding switch DC IN: Connect 9v 1.5A power supply www.flammainnovation.com Shenzhen Flamma Innovation Co., Ltd...
You can adjust the guitar reverb effects from this menu. Press and hold the footswitch again to go back to the previous mode. When any effect is on, you can press the footswitch twice quickly to turn it off. The footswitch LED will turn off indicating the pedal is off. www.flammainnovation.com Shenzhen Flamma Innovation Co., Ltd...
Page 8
OUT and XLR OUT. Switching mode: Unplug the power supply. Press and hold the footswitch while powering on the pedal. The TONE LED and footswitch LED will blink red to indicate that the mode has changed. www.flammainnovation.com Shenzhen Flamma Innovation Co., Ltd...