Table of Contents
Advertisement
OPTION
6.5 OPTION-Parameter 01 - 42
NOTE:
Most of the following parameters exist independently for the bass rotor and treble rotor. To ease the adjustment it
is best to turn the "BALANCE" control to +9 or -9 respectively.
Sequence of the programmable Parameters
LPF
3 BAND EQ passive
6 BAND EQ
X-CUER
INPUT
>oooo< -
(32)
(33)
(34)
(Ol)
(
26
)
(28)
(29) (30) (3l) (2?
(XX)0ptlon Nurr.ber
©-
ROTORS
UJ BASS-TREBLE
1
_
LPF
LEFT
RIGHT
LEUEL
This is so as to recognize the effects of editing these parameters (e.g. level display, non-linear functions...)
GENERAL PARAMETER
MECHANICAL PARAMETER
The general parameters (1-5) influence the basic sound
characteristic of the unit and therefore can be accessed
in normal operating mode just pushing the respective
front panel buttons.
PARAMETER 01 = DISTORTION
This tube-like distorter precedes the rotors and can
reach values ranging between 0 and 15. (15 = high
distortion factor). See also DESCRIPTION PARAME¬
TER page 5-2.
The mechanical parameters control the simulation of the
mechanical characteristics of the cabinet.
PARAM. 06 = SLOW-FAST RATIO BASS ROTOR
PARAM. 07 = SLOW-FAST RATIO TREBLE ROTOR
This parameter determines the speed ratio between
Slow and Fast (Keys 8). The FAST speed remains
constant, whilst the value of this parameter can be
altered from 0 (SLOW Speed at standstill) to 99 (SLOW
SPEED almost FAST).
PARAM. 02 = ROOM
Possible values range between 0 (no reflections) and 15
(large room). See DESCRIPTION PARAMETER, page
5-2.
PARAM. 03 = ROTOR BALANCE
Possible values range between -9 (high bass content) to
+9 (high treble content). See DESCRIPTION PARAME¬
TER page 5-3.
PARAM. 04 = SPEED BASS
PARAM. 05 = SPEED TREBLE
Possible values range between 0 (rotor at standstill) to
99 (high rotation speed).
See DESCRIPTION PARAMETER, page 5-3.
PARAM. 08 = SPEED-UP BASS-ROTOR
PARAM. 09 = SPEED-UP TREBLE ROTOR
This parameter determines the acceleration of the rota¬
tion speed when switching from STOP to SLOW or
FAST.The value is specified in terms of a time and can
be changed from 0 (quick start-up) to 99 (slow start-up).
PARAM. 10 = SPEED-REDUCE BASS-ROTOR
PARAM. 11
=
SPEED-REDUCE TREBLE ROTOR
This parameter determines the braking properties of the
rotor when switching from FAST to SLOW or STOP.
The value is specified in terms of a time and can be
changed from 0 (quick braking) to 99 (slow braking).
Advertisement
Table of Contents
