Explanations Of Each Display Page - Yamaha DTXPRESS IV Owner's Manual

4-4. Press the [SAVE/ENTER] button again. A prompt
appears asking you to confirm the Store operation.
4-5. Press the [SAVE/ENTER] button once more to actu-
ally execute the Store operation.
* To cancel the Store operation, press any button
except for the [SAVE/ENTER] and [SHIFT] buttons.
(When "Are you sure?" appears in the display, the jog
dial will also cancel the operation.)
The following display appears after the Store opera-
tion is complete.
CAUTION
Never attempt to turn off the power while the
message "
ger Setup data may be lost.
" is shown. All Trig-

Explanations of Each Display Page

The following explanations cover the available parameters in the
pages TRG1 through TRG8. To save the edited data, refer to step
4 on page 36.
TRG1 Trigger Setup Select
[Range] 1–11
Selects the Trigger Setup Type (p. 14)
TRG2 Type (Pad Type)
Sets the type of pad that is connected to the input jack assigned in
the upper half of the display ([1SNARE] in the example shown
above).
* Values set in [TRG3 Gain, MVl (Mininimum Velocity)] (p. 38)
and [TRG5 RejTime (Self Rejection Time)] (p. 38) will auto-
matically changed to the proper values for the pad type you
set here.
Pad types are defined as follows.
KP80S/80/65/60
TP100/120SD
TP65S/65 (mainly used as a snare pad) *1
TP65S/65 (mainly used as a snare pad) *1, *2
TP65S/65 (mainly used as a tom pad) *1
TP80S/80/65/60 *3
TP80S/80/65/60 *3
PCY150S
PCY130SC
PCY130S/130
PCY80S/80/65/60/10
RHH130
RHP120SD/120/100/80 (pad side) *4
RHP120SD/120/100/80 (rim side) *4
KP120
BP80 *5
DT series drum trigger (for a snare drum)
DT series drum trigger (for small toms)
DT series drum trigger (for large toms)
DT series drum trigger (for a bass drum)
– Other manufacturer's pads 1 to 6
DTXPRESS
8 Trigger Setup Edit
37
IV
Owner's Manual