Installation - Advantech PCLD-788 User Manual

CHAPTER 2. INSTALLATION
2.1. Initial Inspection
Inside the shipping container, you should find this operating manual
and the PCLD-788 card. The PCLD-788 was carefully inspected both
mechanically and electrically before shipment. It should be free of
marks and scratches and in perfect electrical order on receipt.
When unpacking, check the unit for signs of shipping damage
(damaged box,scratches, dent, etc). If there is damage to the unit or
it fails to meet specifications, notify our service department or your
local sales representative immediately. Also, call the carrier
immediately and retain the shipping carton and packing material for
the inspection by the carrier. We will make arrangements to repair
or replace the unit.
Remove the PCLD-788 interface card from its protective packaging
carefully. Keep the anti-vibration package. Whenever you are not
using the board, please store it in the package for protection.
Discharge any static electricity by touching the back of the system
unit before you handle the board. You should avoid contact with
materials that create static electricity such as plastic, vinyl, and
styrofoam. The board should be handled only by the edges to avoid
static electric discharge which could damage the integrated circuits on
the PCLD-788.
2.2. Connector
CNI : Sixteen channels of input (CHO to CH15).
CN2 & CN3: CN2 and CN3 are 20 pins connectors and the both
have same pins assignment. The signals on these
connectors are multiplexer control signals and the pin
assignments are described as Fig. 2-2-1. The bits C3
to CO are used as multiplexer channel selection
control. The binary value of C3 to CO corresponds