Advertisement
Halex
Electronic Dartboard
4
Setup / Mounting Instructions
Choose a location to hang the dartboard where there is about 10 feet of open space in front
of the board. The "toe-line" should be 7' 9 1/4" from the face of the dartboard
Try to mount
it close to an electric outlet so that you can reach the power source with the AC adapter.
Locate a wall stud and place a mark 60.50" from the floor. Place another mark
14.75" directly above the first mark (75.25" from floor). Center of Bullseye should be
5' 8" from the floor.
Insert 2 mounting screws in the center of the stud using the marks you made as guides.
Be
sure the top screw is directly above bottom screw to ensure dartboard will be level.
Mount the dartboard on the wall by lining up the holes on the back with the screws.
It may
be necessary to adjust the screws until the board fits snugly against the wall.
Wall Stud
ial
Dartboard
Top Screw
75.25",
RIX
|
yes
Bottom
X
Screw
60.50"
5' 8" from Floor
| to Center of
i Bullseye
f
Floor
Halex
Electronic Dartboard
5
Dartboard Functions
RESET button - Cancels cúrrent score and returns to start of game.
and display "SLEEP" on the display after approximately 3 minutes of non-use. However,
the scores are stored in memory and can be restored by pressing any button.
SOUND button - Press to change volume to high, low, or off.
DOUBLE/MISS button - This button is used to activate the Double In/Double Out option for
the "01" games. This function is only active when selecting 301, 401, etc. games. Press the
MISS button if you wish to register a dart that misses the target area.
BOUNCE OUT button - Decide before play if you want to count darts that do not remain in
board (*bounce-outs") or not. If not, simply press the BOUNCE OUT button immediately
after a bounce out occurs to deduct the score that registers.
START button - This multi-function button is used to:
+ START the game when all options have been selected,
+ CHANGE to the next player when one player is finished with his round.
This will put dartboard in HOLD status between rounds to allow player to
remove darts from the target area.
GAME buttons - Press to page through the on-screen game menu.
Display Protective Film
This electronic dartboard may have a clear film over the entire display area to prevent
scratching during shipping. It is recommended that this film be removed before play to
enhance the display area visibility. To remove, simply lift edge, peel off, and discard.
Advertisement
