Table of Contents
Advertisement
en Troubleshooting
Fault
The appliance is not
working.
The programme does
not start.
The door cannot
be opened.
44
Cause and troubleshooting
Check the circuit breaker in the fuse box.
▶
There has been a power cut.
Check whether the lighting in your kitchen or other
▶
appliances are working.
You have not pressed inicio pausa + carga.
Press inicio pausa + carga.
▶
Door is not closed.
Close the door.
▶
Childproof lock is activated.
Deactivate childproof lock.
▶
→ "Deactivating the childproof lock", Page 32
termin. is activated.
Check whether
▶
→ "Buttons", Page 23
Laundry is caught in the door.
Remove any trapped laundry.
▶
The detergent drawer has not been pushed in fully.
Push in the detergent drawer until the symbol goes
▶
out.
The pump for the intelligent dosing system is blocked.
Switch off the appliance.
1.
Clean the pump unit.
2.
→ "Cleaning the detergent drawer", Page 36
Switch the appliance on.
3.
If the display appears again after you clean the
4.
pump unit, call customer service.
→ "Customer Service", Page 53
Note: You can deactivate and manually dose the intel-
ligent dosing system until the fault is rectified.
→ "Buttons", Page 23
The temperature is too high.
Wait until the temperature has dropped.
▶
Cancel the programme.
▶
→ "Cancelling the programme", Page 31
Water level is too high.
Select a suitable programme for draining.
▶
→ "Programmes", Page 25
Power failure.
Open the door using the emergency release.
▶
→ "Emergency release", Page 52
termin. is activated.
Advertisement
Table of Contents
