U S B 2 . 0 H e a d e r s
(9-pin USB6_7)
(see p.2 No. 16)
(9-pin USB45)
(s»ep.2 No. 17)
:
i v P
B e s i d e s f o u r d e f a u l t U S B 2 . 0
p o r t s o n t h e I/O p a n e l , t h e r e a r e
t w o U S B 2 . 0 h e a d e r s o n t h i s
m o t h e r b o a r d . E a c h U S B 2 . 0
h e a d e r c a n s u p p o r t t w o U S B
2 . 0 p o r t s .
Print Port H e a d e r
(25-pin LPT1)
(see
p.2 No. 27)
A c Ó
1
0
S -
W
91-
9 9
T h i s is a n i n t e r f a c e f o r p r i n t
p o r t c a b l e t h a t a l l o w s
c o n v e n i e n t c o n n e c t i o n of p r i n t e r
d e v i c e s .
F r o n t P a n e l A u d i o H e a d e r
(9-pin HD_AUD101)
(see p.2 No. 21)
w
T h i s is a n i n t e r f a c e f o r f r o n t
p a n e l a u d i o c a b l e t h a t a l l o w s
c o n v e n i e n t c o n n e c t i o n a n d
c o n t r o l of a u d i o d e v i c e s .
X1T2 L
JSENSE
172 R
1. High Definition Audio supports Jack Sensing, but the panel wire on
the chassis must support HDA to function correctly. Please follow the
instruction in our manual and chassis manual to install your system.
2. If y o u use AC'97 audio panel, please install it to the front panel audio
header as below:
A. Connect M i c J N (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MlC_RET and OUT_RET are for HD audio panel only. You don't
need to connect them for AC'97 audio panel.
E. Enter BIOS Setup Utility. Enter Advanced Settings, and then select
Chipset Configuration. Set the Front Panel Control option from
[Auto] to [Enabled].
F. Enter Windows system. Click the icon on the lower right hand
taskbar to enter Realtek HD Audio Manager.
For Windows® 2000 / XP / XP 64-bit OS:
Click "Audio I/O", select "Connector Settings" f
> choose
A S R o c k G 3 1 M - G S / G 3 1 M - S
M o t h e r b o a r d