LG LSEL6330 Series Owner's Manual page 18

18 INSTALLATION
WARNING
• If screws are not tightened securely, it can result
in electrical spark and severe personal injury or
death.
1
For power cord installations, hook the strain
relief over the power cord hole (1 3/8") located
below the rear of the oven.
2
Insert the power cord through the strain relief
and tighten it.
CAUTION
• Do not install the power cord without a strain
relief.
3
Remove the lower 3 screws from the terminal
block and retain them.
4
Remove the ground screw and bend the end
of the ground strap up so the slot is over the
hole of the center screw removed in step 3.
5
Insert the ground screw into the power cord
ground wire (green) terminal ring and secure
it to the range frame.
6
Insert the 3 screws through each power cord
terminal ring and into the lower terminals of
the terminal block.
• Make sure that the white center (neutral)
wire is connected to the center lower
position of the terminal block.
7
Tighten the 3 screws securely into the
terminal block.
• The center screw now attaches the bent up
ground strap to the block.
Black
a
White
b
Red
c
Terminal Block
d
Ground Strap
e
Ground Screw
f
Cord/Conduit Connection Plate
g
Bend strap up and attach.
h
3-Wire Connection: Conduit
WARNING
• If screws are not tightened securely, it can result
in electrical spark and severe personal injury or
death.
Conduit Installations
CAUTION
• Do not install the conduit without a strain relief.
1
Remove the cord/conduit connection plate
from the rear of the oven and rotate it.
• The conduit hole (1 1/8") must be used.
2
Prepare the conduit wires as shown below.