Connections - Toshiba 32W1863DG Operating Instructions Manual

Connections

Connector Type
VGA
Connection
(back)
AUDIO IN (**)
PC/YPbPr
Audio
Connection
(side)
AUDIO IN (**)
PC/YPbPr
Audio
Connection
(side)
HDMI
Connection
(back)
Scart
Connection
(back)
YPBPR
YPbPr Video
Connection
(back)
SIDE AV (**)
Side AV
(Audio/Video)
Connection
(side)
SIDE AV (**)
Side AV
(Audio/Video)
Connection
(side)
SPDIF
SPDIF (**)
(Optical Out)
Connection
(back)
SPDIF
SPDIF (**)
(Coaxial Out)
Connection
(back)
HEADPHONE
Headphone
Connection
(side)
USB
Connection
(side)
CI
Connection
(side)
Cables
YPbPr/PC Audio Cable
Side Audio/Video YPbPr/PC Audio
Connection Cable Cable
PC to YPbPr Connection Cable
Audio/Video Cable
Audio/Video
Side Audio/Video
Cable
Connection Cable
English - 11 -
See the illustrations on the left side. You
Device
can use YPbPr to VGA cable to enable
YPbPr signal via VGA input. You cannot
use VGA and YPbPr at the same time.
(**)
To enable PC/YPbPr audio, you will
need to use the side audio inputs with
a YPbPr/PC audio cable for audio
connection.
audio, you will need to use the Side AV
input with a YPbPr/PC audio cable for
audio connection, using the Side AV
connection cable's Red and White ends.
If an external device is connected via the
SCART socket, the TV may automatically
switch to EXT1 mode. When receiving
DTV channels (Mpeg4 H.264, H.265) or
while in Media Browser mode, output will
not be available via the scart socket. When
using the wall mounting kit (available
from a third party in the market, if not
supplied), we recommend that you plug all
your cables into the back of the TV before
mounting on the wall. Insert or remove the
CI module only when the TV is SWITCHED
OFF. You should refer to the module in-
struction manual for details of the settings.
The/Each USB input of your TV supports
devices up to 500mA. Connecting devices
that have current value above 500mA
may damage your TV. When connecting
equipment using a HDMI cable to your TV,
to guarantee sufficient immunity against
parasitic frequency radiation, you have to
use a high speed shielded (high grade)
HDMI cable with ferrites.
If you want to connect a device
to the TV, make sure that both
the TV and the device are turned
off before making any connection. After
the connection is done, you can turn on
the units and use them.
(**) Depending on the model
(**)
To enable PC/YPbPr