Barska AX13094 Manual

Manual for Keypad Safe
Read all instructions before using this safe
WARNING
- For security purposes, change the factory default code as
soon as possible. Default code: 159
- Safe can be opened by either Pin code and/or
Emergency Keys.
- Test and Store emergency keys in a secure place, NOT
inside of the safe.
- Avoid leaving safe door open and unattended; it will allow
unauthorized individuals to reprogram the safe, gaining full
access to the safe and the contents.
- To maximize the security and performance of the safe, test
pin code every 6 months.
- Test and make sure the safe works properly before mounted.
Once tested, mount the safe before use.
- Keep children away from safe; they should not play with or
around the safe at any time. Children at play could
accidentally pull on the safe or accidentally pull on the safe
door causing safe to tip over if not properly mounted.
PARTS OF THE SAFE
D E F G H
A. Bolts
F. Emergency Key Access
B. Battery Cover and
(remove lock cover to expose)
Battery Compartment
G. External Power Supply: 9V battery
C. Initialization Button
(remove lock cover to expose)
D. Knob (Master Key)
H. Key Pad
E. Emergency Lock Cover
I. Indicate Light
OPENING SAFE WITH ACCESS KEY
1. Remove the cover: Push the left side of cover to expose
the key access.
2. Insert emergency key into key access and turn key
counter-clockwise. Hold the key to open position and turn
the knob clockwise to open the door.
NOTE: Once operation is finished, please pull out the
Emergency Key and Keep it in a safe place; NOT INSIDE of
the safe.
INSTALL BATTERIES
1. With the door open, remove the battery cover by sliding
the cover.
2. Insert 4 AA batteries by lining them up in a manner as
indicated by the "+" and "- "signs.
3. Put the arrow of the battery cover align to the arrow on
the compartment, slide the batteries cover back into
place. Restore the battery compartment cover.
NOTE:
DO NOT use any other type of non-alkaline battery.
DO NOT mix new and old batteries.
External Battery Source
9V battery can be used as an external power source. (9V
C B A
battery not included) Please remove emergency key access
cover, then place 9V battery, touching the metal contacts.
Safe should power up, if not switch the polarity of 9V
battery.
I
NOTE:
Only for emergency use
LOCK/UNLOCK SAFE
Unlock Safe with Pin Code
1. On the keypad enter registered pin code 3-8 digits and press
" # " to confirm, the indicate light turns green with 2 beeps.
2. Turn the knob clockwise and pull the door outwards within 5
seconds to unlock the safe.
Lock Safe
Turn the knob counter- clockwise to close the door.
SETTING USER CODE
Default code:159
1. With the safe open, press and release initialization button
located inside of battery compartment, the blue light will be on.
2. On the keypad input new desired Pin Code 3-8 digits and
press "#" to confirm.
3. 2 beeps and the blue light flashes Twice. New Pin Code
registration is completed.
SETTING MASTER CODE
1. With the safe open, Press "00" on keypad.
2. Press and release initialization button, the blue light will
be seen.
3. On the keypad input new desired Pin Code 3-8 digits and press
"#" to confirm.
4. 2 beeps and the blue light flashes Twice. New Master code
registration is completed.
RESET TO FACTORY DEFAULT MODE
Open the safe door and press initialization button for over 5
seconds, a long beep will be heard.
The safe is back to factory default condition.
NOTE: Factory Default Code is "159"
See reverse side for more information
9/22
BC746