NETGEAR ANT24D18 Installation Manual page 6

Statement
of Conditions
In the interest of improving internal design, operational function, and/or reliability, NETGEAR reserves the right to
make changes to the products described in this document without notice. NETGEAR does not assume any liability
that may OCCutdue to the use or application of the product(s) or circuir layout(s) described herein.
Federal C ommunications Commission ( FCC) Compliance N otice:RadioFrequency Notice
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.
To comply with FCC regulations, the ANT24DI8 should only be used with devices that have been FCC approved for
use with the ANT24DI8. Please check the NETGEAR web site at http://www.NETGEAR.com/go/antennas fcc for
the latest information.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or relevision reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures: (I) Reorient or relocate the
receiving antenna, (2) Increase the separarion between the equipment and receiver, (3) Connect the equipment into an
outlet on a circuit different from that to which the receiver is connected, (4) Consult the dealer or an experienced
radio/TV technician for help.
FederalCommunications C ommission (FCC) and EU RadiationExposure Statements
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. In order to
avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna shall not
be less than 50 cm (19.7 inches) during normal operation.
This device should not be co-located with other transmitters.
In the U.S., use of the ANT24DI8 18 dBi antenna with the NETGEAR Booster ANT24BNA can only be used for
point-to-point applications and the antenna and booster must be fixed mounted on a permanent structure.
For EU, use of any antenna requires careful planning and extra consideration to comply wirh EU emissions and health
standards and regulations. It is recommended that a qualified professional installer service is consulted for site survey
and proper installation. Antenna installation must comply with the maximum level authorized by each country. The
ANT24DI8 should only be used with devices that comply with EU regulations for use with the ANT24DI8. Please
check the NETGEAR web site at http://www.NEIGEAR'''(LmLg.m.ntennas eu for rhe latesr information.