Table of Contents
Advertisement
4
Select the Start/Pause button to start the
wash cycle.
5
Make sure that water is supplied, that the
washer does not rock or vibrate excessively,
and that it drains well during the spin cycle.
NOTE
• If water leaks during water supply, see
Connecting the Water Inlet Hoses to connect
them properly.
• If the appliance rocks and vibrates excessively,
see Leveling the Appliance to level it again.
• If the drain does not work, see Connecting the
Drain Hose to install the hose properly.
Testing the Dryer
Once you have completed the installation of the
appliance, use this test to make sure the appliance
is operating properly. This test should be
performed to alert you to any serious problems
with the appliance.
Testing Dryer Heating
Electric Models
Close the dryer door and press the Power button
to turn the dryer on. Press the Time Dry and
Start/Pause buttons to start the test. The air
inside the drum should be warm after the dryer
has been operating for 3 minutes.
Activating the Installation Test
1
Do not load anything in the drum for this test,
as it may affect the accuracy of the results.
2
Press the Power button and then press and
hold the Wrinkle Care and Less Time
buttons.
• This button sequence activates the
installation test. The code
the activation is successful.
• Remove the filters, hold the flap open, and
pour room temperature water inside the
filter housing until you hear a buzzer (about
24 oz / 700 ml). Reinstall the filter.
3
4
5
Error Codes
Check the error code before you call for service.
1Ns
will display if
Press the Start/Pause button.
• The appliance will start the test, which will
last a few minutes.
Check the display for results.
• If operating normally, the product
installation mode is completed without
error code.
End of cycle.
• At the end of the test cycle,
The test cycle will end and the appliance will
shut off automatically after a short delay.
Error
Possible Cause & Solution
Code
Electric dryer power cord is not
Ps
connected correctly, or house power
supply is incorrect.
• Reset circuit breaker or replace
fuse. Do not increase the fuse
capacity.
House fuse is blown, circuit breaker
has tripped, or power outage has
occurred.
• If the problem is a circuit overload,
have it corrected by a qualified
electrician.
The drain hose is not connected
drN
properly.
• Connect the drain hose properly.
• Check if the drain hose is free of
clogs or kinks and is not pinched
behind or under the dryer.
• If the message keeps appearing,
unplug the power cord and call for
service.
The compressor has stopped
LEz
suddenly.
• Unplug the power plug and call for
service.
INSTALLATION
25
ENd
will display.
Advertisement
Table of Contents
