Table of Contents
Advertisement
3
Screw in the band to secure the drain hose of
the dryer onto the stacking bracket.
4
Use the provided tie strap
drain hoses in place.
NOTE
• If the drain hose is too long, do not force it back
into the appliance. This will cause abnormal
noise.
Connecting Hoses to the Drain Hose
Connector
1
Slide the included band clamp onto the end of
the drain hose of the washer.
b
to secure the 2
2
Connect the drain hoses from the washer and
dryer to the drain hose connector. Tighten the
a
band clamp
to keep the washer hose in
place.
3
Use the band clamp
hose (included) to attach it to the bottom
opening of the drain hose connector.
4
Securely connect the short drain hose to a
floor drain or standpipe.
When connecting to a waste spigot, use a
c
band clamp
on the end of the short drain
hose.
CAUTION
• Adjust the wire hose clamp to prevent the hose
from coming loose or leaking. Failure to do so
could result in flooding. Use of the drain hose
connector helps avoid siphoning, odors, or
improper draining.
• Make sure the drain hoses are not kinked or
pinched. This is a potential cause of drainage
problems or noise.
INSTALLATION
b
on the short drain
41"
41"
(105 cm)
(105 cm)
21
Advertisement
Table of Contents
