Table of Contents
Advertisement
06
Installation Instructions
Important Safety Instructions
• Make sure to check the condition of the appliance after
unpacking it. Do not continue with installation if it has been
damaged during transport.
• Safe operation of this appliance can only guaranteed if it has
been professionally assembled and installed in accordance
with these instructions by a qualified technician.
• The individual who assembled and installed the appliance
is liable for damages or faults resulting from an incorrect
assembly or installation.
• Installation and maintenance must be carried out by an
authorised service agent or similarly qualified technician.
• Ensure power to the appliance has been shut off before
carrying out any installation or maintenance.
•
IMPORTANT:
If the power cord is damaged, it must be
replaced by Residentia Group or one of it's authorised
service representatives. Please contact 1300 11 HELP (4357)
and ensure the appliance is completely disconnected from
the power supply.
• When moving or transporting the appliance, do so
cautiously. Do not grasp any salient parts of machine. The
machine door cannot be used as the handle for transport.
If the dryer cannot be transported upright the dryer can be
tilted at an angle of 30°.
• Note that improper handling of the appliance may result in
injury, and damaging of the appliance.
• The appliance is very heavy. Never transport or carry the
appliance alone; instead always do so with the assistance of
at least one other person.
• Remove all obstacles on the transport route and from the
installation location, e.g. open doors and clear away objects
lying on the floor.
• Do not use the open door as a handhold.
• Remove and responsibly discard of all packaging material
before installing or using the appliance. Children can
become entangled in the packaging film or swallow small
parts and suffocate. Do not allow children to play with the
packaging.
• Do not install the clothes dryer in a room where there is a risk
of frost occurring. At temperatures around freezing point the
appliance may not be able to operate properly. There is a risk
of damage if the condensed water is allowed to freeze in the
pump and hoses.
User Manual
OHPD800W
• The appliance must not be installed behind a lockable door,
a sliding door or a door with a hinge on the opposite side to
that of the clothes dryer, in such a way that a full opening of
the dryer door is restricted.
• Do not restrict the floor clearance through deep pile carpets,
strips of wood or similar. This might cause heat built-up
which would interfere with the operation of the appliance.
• It is recommended that, for your convenience, the machine is
positioned close to your washing machine.
• The clothes dryer must be installed in a clean place, where
dirt does not accumulate. Air must be able to circulate freely
around the appliance. Do not obstruct the front air inlet or
the air intake grilles at the back of the machine.
Levelling Procedure
• To keep vibration and noise within minimum level when the
dryer is in use, it must be placed on a firm and level surface,
and using the adjustable feet must be installed level. Note
that the feet must never be removed.
• Once in its permanent operating position, check that the
dryer is absolutely level with the aid of a spirit level. If it is not,
adjust the feet by hand or using a tool.
• Make sure that the voltage of the power supply is the same
as the electric specification.
• Do not connect the dryer with the power connection board, a
universal plug or socket, do not use multi-plug adapters and
extension cables.
Advertisement
Table of Contents
