Unpacking And Set-Up Instructions; Parts And Features - Pelonis NY1507-20MB Owner's Manual

UNPACKING AND SET-UP INSTRUCTIONS

Unpack your heater and find the wheel holding plates and butterfly nuts
between the fin assemblies.
1. Make sure the heater is unplugged and the
power and setting control is in the "0"
(OFF) position.
2. TURN THE HEATER UPSIDE DOWN.
3. Attach the wheel holding plates onto the
heater as Figure shows. One is fixed
between the last two fins and the other one
is fixed next to metal control box.
4. Insert the butterfly nuts and tighten them securely.
5. TURN THE HEATER UPRIGHT.
Your heater is now ready to use.
CAUTION:
assemblies attached. Operate heater in upright position only (wheels on
bottom, controls on top). Any otherposition could create a hazardous situation.

PARTS AND FEATURES

IMPORTANT!
Your heater is equipped with a
polarized alternating current
lineplug (a plug having one
bladewider than the other).
This plug will fit into the power
outlet only one way. This is a
safety feature. If you are
unable to insert the plug fully
into the outlet, try reversing the
plug. If the plug should still fail
to fit, contact your electrician to
replace your outlet. DO NOT
defeat the safety purpose of
the polarized plug.
A
Power Indicator Light
B
Thermostat Control
Risk of fire – Do not operate heater without wheel
Control Panel Features
A
B
C
C
Power and Setting Control
3
Butterfly nuts
Wheel holding
plate
Metal control
box
Cord wrap