IAR SYSTEMS STZ-SECAPP-V1 User Manual page 11

4
Connect the PC and the PC port on the Security Appliance using the USB-
C to USB-A cable.
B. Connecting the hardware provisioning
equipment
When the Security Appliance has been connected to the PC, you can connect the
hardware provisioning equipment to the Security Appliance. These components
are needed:
Item Component
1 Security Appliance
2 I-jet Debug probe
3 Prototyping board—not included in the kit
6 USB Micro cable
1
Attach a USB Micro cable to the DN1 port on the front panel of the
Security Appliance and attach the other end of the cable to the I-jet debug
probe.
2
Attach one end of the 20-way ribbon cable to the I-Jet debug probe, and
the other end to the development board. Note the keying (pin 4 is
missing).