Simplicity 1003 Operator's Manual page 21

Hide thumbs Also See for 1003:
Table of Contents

Advertisement

Assembly
HimnlScSiu
FORWARD CONTROL ROD ASSEMBLY
FOR BOTH MODELS 1003 AND 1005, PROCEED
AS FOLLOWS:
lsert control?row (iWr
mm,
t%ui
EerXitem.:B).
A Cable Clip
B Lever
C Forward Rod
D Reverse Rod
Figure 24. Cable Clip
j Attachment of control rod is 'different for earliertl
style bellcrank and later style bellcrarik' To deter-tj
mine which belLeiank*j,s. installed, on tiller, see*!
lEigure. 25.4
HE ;
■''
m
flOlJpTIN
Forward cq
smsEaiNfi
!
V/ JDQEOTSB
Riijihis'jhole is l|r cdnnec'tinalrev^se a^onSoil?
igure 25. Earl
2. j For earlier style bellcrank, insm~hook"mid"oH
spring (item A, Figure 26) in top hole of left
J
jbellcr^ik fitem Ek %oi^te^tvtebdicKa^|Sk. ype|B
jhook enaPof <pn®g|g Jj^p^fC^fd^nejneJ
f&wald.
(s&e f igure 25)7
3. fSlip the'wire"clamp (ifempB, figure':
I of the controlrod (item C),
%,
4. Feed the control rod through the spring and
hook the eyelet end of spring over the set¬
screw (item D) in the wire clamp.
Be sure
the control rod is to the IKM of the bell¬
crank (item E).
5. With the control lever (item B, figure 24)
completely down, position the forward idler
pulley 1/4 inch (6 mm) from the left-hand
frame and tighten the setscrew (item D, figure
A
Spring
B
Wire Clamp
C
Control Rod
D
Setscrew
E
Bellcrank
1/4" (6 mm)
TTurr
Figure 26. Forward Control Rod Assembley
REVERSE CONTROL ROD ASSEMBLY
FOR THE MODEL 1005 ONLY, PROCEED AS
FOLLOWS:
Insert the remaining control rod (item D, fig¬
ure 24) through the reverse control lever.
When installed the reverse control rod should
cross under the forward control rod.
e i@veps;e control!
The ggts<^ew|^i^;'was,]^^al^^^wffe clamp|
(hems B aiid 'C, I^h^^^PbSieWvets;e control]
rod are piea^enJfledlpSaye right bellcrank (item]
,J|) in top hole, Tins h&le is stamped .5-R on later]
sjyle bellcrai^]^®osen fie sellcrfl/ only enough]
to slip thcerSfofSthe control rod (item A) through]
the wire clamp. The control rod must be on the
bellcrank^
T~' TST
"7-
3. With the control lever completely down and
the reverse idler pulley (item E) resting against
the frame, tighten the setscrew to hold the
control rod in place.
19

Advertisement

Table of Contents
loading

This manual is also suitable for:

1005

Table of Contents