Table of Contents
Advertisement
Adjustments
fwimaUcitu
Figure 20. Model 1 003 Pulley Alignment
For model
1005
tillers, the reverse pulley (item
B,
figure 21) should be positioned so there is a gap of
0.20
inch, or
13/64
inch
(5.2
mm), between pulley
face and shaft seal.
A
distance of
1-1/2
inches
(38
mm)
from center to center of the two drive pulleys
is then correct. Loosen engine pulley setscrews and
adjust as required. Be sure setscrews are retighten¬
ed securely.
Visually check alignment of pulleys (items
A,
B and
D). If pulleys are not aligned properly, loosen set¬
screw in worm gear drive pulley (item D) and move,
forward or backward as required.
Retighten set¬
screw securely.
Figure 21. Model 1005 Pulley Alignment
A Forward Drive Pulley
B Reverse Drive Pulley
C Idler Pulleys
D Worm Drive Pulley
0
Advertisement
Table of Contents
