Hamilton Beach Commercial GH04 Operation Manual page 3

25. Unplug the appliance and inspect the
power cord insulation for cracks on
a weekly basis. Refer to "Technical
Services" for repair or replacement.
26. This product is only intended for the
preparation, cooking, and serving of
foods. This product is not intended
for use with any nonfood materials or
products. Do not use in an explosive
atmosphere.
w WARNING
Pinch, Cut, and Crush Hazard
Make sure that the blender is off and
unplugged before installing or removing
attachments and parts.
Blades are sharp! Use extreme care
when handling.
Only hold blender in designated
gripping areas. See instruction details.
DO NOT reach or insert utensils into the
container while the blender is running.
Failure to follow these instructions can
result in broken bones, cuts, or other
serious injuries.
This Operation Manual provides the user with instructions to safely operate, clean,
and maintain the Immersion Blender. It is intended to facilitate use of the appliance
(hereinafter referred to as "appliance"). It is mandatory that all users in charge of
installing, commissioning, operating, maintaining, repairing, or dismantling the machine
read this manual and be properly trained for all required responsibilities. This manual
must be carefully kept at the workplace and be readily available for the user to consult.
The applicable safety, hygiene, and environmental standards/regulations enforced in the
country where appliance is operated must always be applied during use.
Motor Overload Protection
This Immersion Blender is equipped with motor overload protection. If motor stops during
operation due to overheating, unplug and allow Immersion Blender to cool down for 15
minutes. Plug Immersion Blender back in after 15 minutes to resume normal operation.
SAVE THESE IN STRUC TIONS
27. To avoid an electrical circuit overload,
do not use another high-wattage
appliance on the same circuit with this
appliance.
28. ONLY switch on the machine when
the blender blades are immersed.
29. DO NOT allow water/mixture to enter
the motor housing slots when using
or cleaning.
w WARNING
Electrical Shock Hazard
Do not use an extension cord.
Do not put motor housing, cord, or
plug in water or any other liquid.
Failure to follow these instructions can
result in death, fire, or electrical shock.
3