Table of Contents
Advertisement
Use the following steps to perform an initial configuration of the MSI OTM.
1. Connect power to the Oil Tank Monitor. The following sequence of events will occur:
a. The OTM displays "Heat-Timer Corp. V 1.00 2013" followed by "Oil Tank Level Monitor".
b. The OTM displays "Level= [xxx] " where [xxx] is the oil level in the tank, in inches.
c. After the oil level is displayed, the internal oil pump turns on to update the oil level reading. The OTM displays
"Pump activates".
d. After the pump finishes, the OTM updates the display to show the current oil level in the tank.
2. Enter programming mode and configure the following settings (refer to "Programming the OTM" on page 10 for information):
• Oil Type – Select the oil type used in the system (Oil #2, Oil #4, or Oil #6).
• Bottom Offset – If a petrometer is installed, set the Bottom Offset so the OTM and petrometer display the same oil level.
Heat‐Timer Corp.
Startup Instructions
Startup Instructions 9
059411-00 Rev. A
Advertisement
Table of Contents
