Advertisement
7
Power cannot be turned on.
| * The battery is exhausted.
e The battery is not installed.
| The tape does not run when the
VTR button on the video camera or
on the lens is pressed.
e The tape is at its end.
e The cassette is in record prevention mode. (See page 24.)
e The tape has sticked to the head drum. Remove the cassette and reinsert it.
The tape does not run when the
tape transport button on the VTR is
pressed.
e The tape is at its end.
——
There is no sound in E-E mode
(for details, see the E-E mode
description on page 11.)
e The POWER switch on the video camera is set to OFF.
« The safety tab on the cassette is slid out (in record prevention mode).
(See page 24.)
Power has turned off during
operation.
e The battery is weak.
| The battery is quickly discharged.
The cassette cannot be ejected.
The playback picture is not clear.
Audio recording cannot be made.
The recorded sound is distorted.
The recorded sound is noisy.
34
e The ambient temperature is too low.
e The battery has not been charged fully.
e The battery is exhausted.
e The POWER switch is turned off.
e The video heads may be contaminated. Clean the heads using the video head
cleaning cassette (not supplied). (Do not use a commercially available wet-type
cleaning cassette. It may damage the video heads.)
e The AUDIO LEVEL controls are set to the minimum position.
e The audio recording level was too high.
e The audio recording level was too low.
Advertisement
