Advertisement
Set the VTR in the recording pause mode, and press the
REC REVIEW button on the video camera. The tape is
rewound for 2 seconds and the VTR automatically starts to
playback the last scene and stops at the previous position.
Check the recorded picture on the viewfinder and the
recorded sound through the speaker or earphone.
Recording pause mode is resumed.
If the unit is left in the recording pause mode for about 5
minutes, the unit automatically enters the stop mode in
order to protect the tape.
When the safety tab on the cassette is slid out to prevent
accidental erasure, or the POWER switch on the video
camera is set to OFF, you cannot make a recording.
Set the POWER
switches on the VTR and the
video camera to on.
Insert a cassette.
Point the video camera at the subject, and adjust
.
the video camera to make it ready for operation.
(Refer to the instruction manual of the video camera.) «
Press the VTR button on the video camera or the
lens.
Recording will start.
(But, it takes a few seconds for the servo-
mechanisms to lock in.)
To enter the recording pause mode, press the
VTR button on the video camera or on the lens
during recording.
To stop recording, set the VTR to the recording
pause mode, then press the STOP button on the
VTR.
Run the tape for about 15 seconds at the beginning of a
cassette before recording. It prevents you from missing the
starting point when starting playback or leaving the
previously recorded portion when recording on the recorded
tape.
Monitor the sound through the speaker or the earphone
connected to the EARPHONE jack. Select the monitor
sound with the MONITOR SELECT switch.
25
Advertisement
