Advertisement
SERVICE
AND ADJUSTMENTS
ENGINE
TO ADJUST CARBURETOR
TO ADJUST
THROTTLE
CONTROL
CABLE
(See Fig.
30)
The throttle control has been preset at the factory and
adjustment should not be necessary.
If adjustment is
necessary, proceed as follows:
•
With engine not running, move remote throttle control
lever to "FAST" position,
•
If throttle lever on engine touches high speed stop, no
further adjustment is necessary. If throttle lever does
not touch high speed stop, continue with adjustment
procedure,
•
Loosen cable clamp screw.
•
Move throttle lever up until it touches high speed stop,
and hold in this position,
•
Tighten cable clamp screw securely.
The carburetor
has been preset at the factory and adjustment
should
not be necessary.
However,
engine
performance
can be affected by differences
in fuel, temperature,
altitude
or load,
If the carburetor
does need adjustment,
contact
your nearest authorized
service
center/department
IMPORTANT: NEVERTAMPERWlTHTHE ENGINEGOVERNOR,
WHICH IS FACTORY SET FOR PROPER ENGINE SPEED.
OVERSPEEDING THE ENGINE ABOVE THE FACTORY HIGH
SPEED SETTING CAN BE DANGEROUS.
IFYOU THINKTHE
ENGINE-GOVERNED
HIGH SPEED
NEEDS ADJUSTING,
CONTACTYOU R NEAREST AUTHORIZED SERVICE CENTER/
DEPARTMENT, WHICH HAS THE PROPER EQUIPMENT AND
EXPERIENCE TO MAKE ANY NECESSARY ADJUSTMENTS.
CLAMP SCREW
CASING
AND WIRE
THROTTLECONTROL
FIG. 30
18
Advertisement
