Table of Contents
Advertisement
BT-H1350Y
the same level
Fig. 19
6. Disconnect an Oscilloscope from
МДМА
and con-
nect an Oscilloscope to RIP WES.
7. Adjust
L618 so that the levels D, E and F are same
level as shown in Fig. 20.
E
the same level
Fig. 20
. Disconnect
an Oscilloscope from
REZWEM
and con-
nect an Oscilloscope to IZ NEI.
. Confirm
that the levels A and C are same
level as
shown in Fig. 19.
PULSE CROSS CIRCUIT ADJUSTMENT (A/B/E-P.C.
board)
1. EQUIPMENT TO USED
Oscilloscope
Video Generator (NTSC and PAL/SECAM)
2. ADJUSTMENT PROCEDURE
1. Set the Input Selector switches to LINE A.
2. Set the TV System Selector switch to NTSC.
З. Set the H/V Delay Switch НН to ON.
4. Input a Red Signal to LINE A terminal.
5. Connect an Oscilloscope to
апа
ЕРІ.
Monitor TV
Fig. 21
6. Adjust R5444 (Burst sampling for pulse cross) so that
the false burst for
Б ЖЕ]
епїег within clamp pulse
of
MUS
as shown in Fig. 22.
ТР
A15
TPE1
Fig. 22
Advertisement
Table of Contents
