Assembly Instructions; Fitting The Wheels; Mounting The Grip Handles; Operation - Parkside PGK 1400 B2 Translation Of The Original Instructions

GB IE
ment for longer periods of time
or if the unit is not held or main-
tained properly.
Warning! During operation,
this electric equipment gener-
ates an electromagnetic fi eld
which, under certain circum-
stances, may impair the func-
tionality of active or passive
medical implants. To reduce
the risk of serious or lethal
injuries, we recommend
that persons with medical
implants consult their doctor
and the manufacturer of their
medical implant before oper-
ating the machine.

Assembly instructions

Always disconnect the equipment
from the mains before conducting
any work on it.
Make sure during assembly that the
device cable (21) is not pinched
and has enough play.

Fitting the wheels

1. Attach the wheels (6) on the right and
left side of the chassis (5).
2. Attach one washer (22) each on the
right and left side of the chassis (5).
3. Place one circlip (23) each through the
chassis (5).
4. Slide the circlips (23) over the ends of
the chassis (5).
5. Clip one hubcap (24) each into the
wheels (6).
Removing the wheels
1. Reach into the hubcaps (24) and pull
them off.
26
2. Remove the circlips (23).
3. Remove the washers (22).
4. Pull the wheels (6) off the chassis (5).
Mounting the grip
handles
1. Fasten the central bar (3) onto the
lower bar (4). Use a screw, wing nut
and washer (11) to fasten.
2. Attach the handlebar (1) to the central
bar (3). Use a screw, wing nut and
washer (11) to fasten.
When properly mounted, the ends
of the handlebar will point away
from the front of the appliance (see
illustration
3. Fix the device cable (21) with the cable
clamp (10).

Operation

Observe noise protection rules and
other local regulations.
Before putting into
operation
1. Fold the handlebars (1+3) up.
2. Fix the handlebars (1+3) with the wing
nuts (11).
3. Firmly hold the appliance with one
hand on the central bar (3).
4. Release the lock on the chassis (18) by
pulling on the ring.
5. Switch to one of the working positions
(20).

Switching on and off

Before switching the equipment on,
make sure that the equipment is
).