Table of Contents
Advertisement
c'
Operation
Filter Cleaning
The filter should not be cleaned if replacement filters are available.
1.
Remove the filter cover that is inserted in the front panel by pulling firmly
towards you (as you face the drive) to disengage the cover catches
(see Figure 3-3).
2. Remove the filter (see Figure 3-4).
3. Clean the filter by agitating it in a solution of water and mild detergent.
4. Rinse the filter thoroughly with clean running water and allow it to dry
completely.
5. Install the filter.
IMPORTANT
Be sure not to disturb the maintenance toggle switch (MSU99111
9912). It must be down (OFF).
6. Replace the filter cover by aligning the catches on the cover with the slots on
the panel and pushing until the catches snap into place (see Figure 3-5),
3-5
HD42.oo
Advertisement
Table of Contents
