Cobalt Digital Inc WAVE Control Series Quick Start Manual

The WAVE Control Series - Control Panel has an easy-to-use front panel which enables intuitive operations of
router access with minimal keystrokes when using the Destination Oriented firmware which is supplied as
delivered from the factory. Consult the Owners Manual if you wish to switch the control panel firmware to
Select and TAKE operation.
Note: The Control Panel does not require any special ventilation clearance with its passive cooling design,
however it is always advisable to leave as much clearance between adjacent equipment as possible.
Perform CP-78 control panel connections as described below:
1. Connect an RJ-45 Ethernet cable from the control panel to your LAN which also has a WAVE router
frame and a admin computer for communications with the different hardware.
2. Connect the 12vdc power brick connector to the control panel.
3. Connect the mains AC to the power brick mains AC connector. The panel does not have a power
switch, it should boot up in less than 30 seconds.
4. When you are ready, you can change to DHCP by changing the dip switches to FORCED DHCP and
pressing the RESET button found under the plastic cover next to the dip switches or unplug the external
power, wait 10 seconds and re-power the unit.
5. Using the web browser UI, assign the router hardware of choice to the ROUTER button number on the
control panel.
Page 1 of 2
REV .02 QUICK START GUIDE 2024