Radioddity GC-5 Manual Programming Steps
To enter a channel from the front panel, the steps below should help:
The Menu(Green) key is used to invoke the Menu system, Enter the selection part of an option, and
Confirm that option.
The Back (Red) key is used to exit a Menu option (or it will automatically return after a short delay)
Once the repeater Receive frequency is entered via the VFO Mode and using the Keypad, the Menu
options will help you set the other parameters.
Example:
2m Repeater
146.685 Receive frequency
The offset is .6 MHz
Shift Direction is - (minus)
Transmit CTCSS Tone is 100 Hz
Receive CTCSS Tone is 100 Hz
Enter VFO (Frequency) Mode using VFO/MR key.
Use the Keypad to enter 145685 (the Decimal Point and extra 2 Zeros will be added automatically)
Press Menu, Option 2 TX power
Press Menu to Select
Use Up/Down Arrows as needed to select the Power setting
Press Menu to Confirm
Exit to Return (or scroll to the next Option)
Press Menu, then 1 2 to set TX CTCSS tone
Press Menu to Select
Use Up/Down Arrow as needed to scroll to 100.0 Hz, or press the first 3 digits (1 0 0), scroll to 100.0
Hz
Press Menu to Confirm
Exit to Return (or scroll to the next Option)
Press Menu, then 1 0 to set RX CTCSS tone
Press Menu to Select
Use Up/Down Arrow as needed to scroll to 100.0 Hz, or press the first 3 digits (1 0 0), Scroll to 100.0
Hz
Press Menu to Confirm
Exit to Return (or scroll to the next Option)
Press Menu, then 2 8 to set Shift Direction
Press Menu to Select
Use Up/Down Arrows as needed to scroll to Minus