BMW S 1000 XR 2022 Rider's Manual page 88

82 OPERATION
with Dynamic ESA Pro
Immediately after button 1 is
pressed, the settings for damp-
ing 2 and spring preload 3 are
displayed.
Immediately after button 1
is pressed, the settings for
damping 2 and spring pre-
load 3 are displayed. The set-
ting shows briefly, then disap-
pears automatically.
Adjusting suspension damping
Switch on the ignition (
Short-press button 1 to view
the current setting.
When button 1 is pressed
again, this message appears:
OE
D-ESA Pro required.
Cannot adjust damping.
with Dynamic ESA Pro
To adjust damping:
Repeatedly short-press but-
ton 1 until the setting you
want to use is displayed.
the motorcycle is on the move.
Selection arrow 4 appears and
subsequently disappears after
the change of status.
66).
The following settings are avail-
able:
Road
able on-road riding
Dynamic
dynamic on-road riding
The setting shown on the
display is automatically
accepted as the setting for
suspension damping if you
allow a certain length of time
You can adjust the damp-
ing characteristic while
: Damping for comfort-
: Damping for
OE