Table of Contents
Advertisement
Installing the Wi-Fi Kit
Tenant address
A
B
C
D
E
F
- e.g. When you set the tenant address of a Wi-Fi Kit to 2 through the S-NET pro 2,
the Wi-Fi Kit can control and monitor the indoor units with the RMC1 set as 2.
4) Select the [Apply] button to save the specified tenant address for the Wi-Fi Kit.
• To set the group channel address for indoor units, see "Setting the indoor unit address" in
Installation Manual of the indoor unit.
NOTE
[SEG9: 1 (for RMC address mode), SEG11: RMC1 address setting]
• To set the tenant address upon request, contact the Samsung service centre.
• To control all indoor units with different tenant addresses, make sure that all the Wi-Fi Kits are
registered to the smartphone.
• When using the multi-tenants feature for Wi-Fi Kits, the upper-level controllers (touch centralized
controller, DMS) other than the OnOff controller can be installed at the same time.
Checking the Wi-Fi Kit
Power LED
Wi-Fi connection LED
Wi-Fi setting LED
AP button
Reset button
Items on the LED display
Item
1
2
3
AP connected, Internet connection incomplete
14
Group channel address for the indoor units controlled by a Wi-Fi Kit
Controls the indoor units with the group channel address "A"
Controls the indoor units with the group channel address "B"
Controls the indoor units with the group channel address "C"
Controls the indoor units with the group channel address "D"
Controls the indoor units with the group channel address "E"
Controls the indoor units with the group channel address "F"
LED indication
Initialized
General
<Front panel of the Wi-Fi Kit>
Power supply
On
On
On
Wi-Fi connection
Wi-Fi setting
On
On
Blinking
On
Off
Off
Advertisement
Table of Contents
